I remember my old engine would ocassionally do this too...can't remember why though. It will start immediately, but even if I floor it, it does not run very fast.
It's very rough and there's smoke coming out of the exhaust. It just goes "put-put-put". I had off the valve cover and everything looked good and it ran fine until now.
Should I run it and wait for it to warm up and run good, or is something wrong here?
Perhaps it's flooded?
Is it carb'd? I dunno..if it is maybe the linkages or cables aren't in good condition and it isn't allowing it to open up... Or maybe it is flooded...but you'd think after a few minutes of running it would become clean again...
Also...what about the sleeves? pistons? Maybe there's a leak within the cylinder or something...
It's fuel injected and turbocharged. I'll try running it for a while and see if it smooths out. I think it used to eventually smooth out with the old engine.
Oh...fuel injection. <_< Probably flooded...but what woulda caused the flooding?
QuoteOh...fuel injection. <_< Probably flooded...but what woulda caused the flooding?
A lot of rain. :lol:
Could possibly be in the ignition system, have you pulled the cap off and checked it out? If its running rough and sputtering it may have a timing problem of some sort.
QuoteCould possibly be in the ignition system, have you pulled the cap off and checked it out? If its running rough and sputtering it may have a timing problem of some sort.
Could be the finicky crank angle sensor. There's a reason why they only made those things in 1981. I have a buddy from the Z car club with the same engine so I'm going to ask him.
I'm also thinking the turbo might be an issue here.
Maybe if the turbine is froze, but if its free it should still idle fine.
If those sensors are a known problem odds are good it could be that.
QuoteQuoteOh...fuel injection. <_< Probably flooded...but what woulda caused the flooding?
A lot of rain. :lol:
(http://forums.maxima.org/images/smilies/slap.gif)
QuoteQuoteQuoteOh...fuel injection. <_< Probably flooded...but what woulda caused the flooding?
A lot of rain. :lol:
(http://forums.maxima.org/images/smilies/slap.gif)
LOL! :lol:
QuoteQuoteQuoteOh...fuel injection. <_<? Probably flooded...but what woulda caused the flooding?
A lot of rain. :lol:
(http://forums.maxima.org/images/smilies/slap.gif)
Maxima.org has the best smilies. :praise:
QuoteMaxima.org has the best smilies. :praise:
org smilies (http://forums.maxima.org/misc.php?do=getsmilies&wysiwyg=0&forumid=11)
enjoy
Smoke? Flooding does not cause smoke, unless its a 2-stroke (http://forums.maxima.org/images/smilies/fart.gif)
There could be an oil leak, like a bad ring, or the oil needs changing, the plug wire could also be damaged, one on my truck melted and there was blue smoke out the pipes and it puttered.
It sounds like it is running too rich. Check your fuel pressure regulator for leaks and proper operation. There shouldn't be any fuel in the vaccum hose connected to it. Also you could have a bad O2 sensor. Pull the plugs and tell us how they look.
It was the spark plugs. I was running a bit rich before so it made the cheap POS Autolites foul out. I put the in the NGKs from my old engine and it fired right up and ran good!
QuoteIt was the spark plugs. I was running a bit rich before so it made the cheap POS Autolites foul out. I put the in the NGKs from my old engine and it fired right up and ran good!
3rd Gen Maximas run like shit unless your using NGK plugs. I always thought it was just the 3rd gen that needed NGK plugs to run right.
Glad the problem's solved... ^_^
You might wanna fix the running rich unless you like replacing spark plugs...
QuoteIt was the spark plugs. I was running a bit rich before so it made the cheap POS Autolites foul out. I put the in the NGKs from my old engine and it fired right up and ran good!
Heh heh...until they foul from the rich mixture! A slightly rich mixture typically won't cause issues, but if it was enough to foul the plugs, you'll be swapping plugs again before too long!
My personal experience has shown that either Autolite or NGK are good plugs.
The MAF (Mass Airflow Sensor) is notorious for causing drivabilty problems like that on 280zx/300zx models.
Anyone have a spare in your Z club you can hot swap and see if it goes away?Takes only a minute or two to swap out.
EDIT..Didnt notice you ID'ed the problem already. Stick with NGK's for now on!